Vista activesync issue

Hi, - Have you made any changes to your computer prior to the issue? Follow these steps and check if they help. Step 1: Try re-registering Time service. How satisfied are you with this reply?

Thanks for your feedback, it helps us improve the site. This site in other languages x. Make sure that your method of connection is checked. Then click the "Get Connected" button. Once it finishes it shows a report that contains enough information on where you need to look for the problem. In many cases other programs such as cellphone or pager utilities that use serial connections may have the port open without your knowledge If you were connected to COM2 in the above case and couldn't connect, one possibility is a bad cable or even a bad serial port in the PC.

Here's a tip Before giving up, soft reset the PPC and give it one more shot. The "Not Installed" message is applicable to other ports as well If you know that the port exists, you may have to turn it on in your PC's bios, and you may have to prod the computer into "finding" the port by running "Add New Hardware" in the control panel and get the PC to search itself again. Note that there is no reference to attempting a Network connection.

Network Sync connections must always be initiated manually on the PPC and ActiveSync will never try to initiate a network connection from it's end. However, if the sync cable is plugged into a different USB port on the PC or the hub that was used initially, or if a hub is plugged into the PC port that was used and the connection made through a hub, the problems arise.

It would be my guess that Activesync "sees" the connect on the new port, but attempts to communicate out through the original port, not only precluding a successful connect, but potentially disrupting any device that is now connected to that original port.

Connect PPC and confirm that it is on. In some cases, the IR port may have to be turned on in the laptop's bios. Check the Device Manager, find the IR port and confirm that it is "working properly. Activate some type of IR action such as sending a file with IR from Explorer and put the ports together and confirm that the laptop "see's" the CE device by checking the IR icon in the systray.

If not, this must be resolved before going any further! Click on "Get connected" When the process finishes, check the result dialogue and confirm that the IR port was available. Once the "Get Connected" result shows IR as "Available," it's time to power up the CE device, confirm that it is attempting a connect and at the same time click the "Retry" button on the "Get Connected" results screen.

If the connect fails, immediately click the "Retry" button once more in case the attempts were "out of sync. Feedback will be sent to Microsoft: By pressing the submit button, your feedback will be used to improve Microsoft products and services. Privacy policy. The content in this article is for Windows Mobile Device Center which is no longer supported. The corresponding downloads have been removed from the Microsoft Download Center. To access your phone on your PCs, use Your Phone application on your system.

Windows Mobile Device Center offers device management and data synchronization between a Windows Mobile-based device and a computer. Download and install Windows Mobile Device Center 6. You can use Windows Mobile Device Center 6. To determine which Windows Mobile operating system you're using if your phone doesn't have a touch screen, click Start , click Settings , and then click About.

If your phone has a touch screen, tap Start , tap the System tab, and then tap About. Best Home Security Systems. Best External Solid State Drives. Best Portable Chargers.

Best Phone Chargers. Best Wi-Fi Range Extenders. Best Oculus Quest 2 Accessories. Best iPad Air Cases. Awesome PC Accessories. Best Linux Laptops. Best Wireless iPhone Earbuds. Best Bluetooth Trackers. Best eReaders. Best VPN. Browse All News Articles. Windows 11 Uninstall Clock.